Pioneer Super Tuner III DVH-P7050 - Manual (Page 70)

Initial Settings for
DVD player
Setting remote control code type
When the remote control operation switch is set
to
DVD , changing the remote control code type
enables you to operate the Pioneer DVD player
by the supplied remote control. There are three
remote codes, code type
A , code type B and
code type DVH .
When using this unit with an Multi-DVD Player
(e.g. XDV-P9), select code
A .
When using this unit with a DVD Navigation
Unit, select code
B (Not used).
When using this unit only, select code DVH .
1 Set the remote control selection switch on
the left side of the remote control to the
appropriate position with a pen tip or other
pointed instrument .
• If you select
DVH mode, there is no need to
take the following procedure.
• If you select A/B mode, take the following
procedure and change the code type to the
appropriate type.
2 Pressing 7 and 0 on the remote control
simultaneously changes the code type.
Initially, the code type is set to
A .
Each time you press 7 and 0 simultaneously on
the remote control the code type changes
between
A and B .
If you forget your code number
Refer to Changing the Level, step 3 on page 66,
and press
CLEAR 10 times.
The registered code number is canceled, letting
you register a new one.
En 70
09
Section