Pioneer Super Tuner III DVH-P7050 - Manual (Page 19)

Tuner
En 19
Listening to the radio
These are the basic steps necessary to operate
the radio. More advanced tuner operation is
explained starting on page 20.
Important
If you are using this unit in North, Central or
South America, reset the AM tuning step (see
Setting the AM tuning step on page 72).
1 STEREO ( ST ) indicator
Shows that the frequency selected is being
broadcast in stereo.
2 BAND indicator
Shows which band the radio is tuned to, AM
or FM.
3 PRESET NUMBER indicator
Shows what preset has been selected.
4 FREQUENCY indicator
Shows to which frequency the tuner is
tuned.
1 Press SOURCE to select the tuner .
Press SOURCE until you see Tuner displayed.
• Pressing SOURCE on the head unit also per-
forms the same operation.
2 Use VOLUME to adjust the sound level.
Press VOLUME to increase or decrease the vol-
ume.
• Rotating
VOLUME on the head unit also
increases or decreases the volume.
3 Press BAND/ESC to select a band .
Press BAND/ESC until the desired band is dis-
played, FM1 , FM2 , FM3 for FM or AM .
• Pressing BAND/ESC on the head unit also
performs the same operation.
4 To perform manual tuning, press
1 or
¡ with quick presses.
The frequencies move up or down step by step.
• Pressing
2 or 3 on the head unit also per-
forms the same operation.
5 To perform seek tuning, press and hold
1
or
¡ for about one second and release.
The tuner will scan the frequencies until a
broadcast strong enough for good reception is
found.
• You can cancel seek tuning by pressing either
1 or ¡ with a quick press.
• If you press and hold
1 or ¡ you can skip
broadcasting stations. Seek tuning starts as
soon as you release the buttons.
• Pressing
2 or 3 on the head unit also per-
forms the same operation.
Note
• When the frequency selected is being broad-
cast in stereo the STEREO (ST) indicator will
light.
1 2 3
4
English
Español
Deutsch
F
rançais
Italiano
Nederlands
03
Section