Pioneer Super Tuner III DVH-P7050 - Manual (Page 73)

Initial Settings
En 73
2 Select AUX on or off with
E or e.
Pressing E or e will switch
AUX between on
and off and that status will be displayed (e.g.,
AUX :ON ).
• Pressing 5 or ∞ on the head unit also per-
forms the same operation.
Switching the dimmer setting
To prevent the display from being too bright at
night, the display is automatically dimmed
when the car’s headlights are turned on. You
can switch dimmer on or off.
1 Press F to select DIM .
Press F repeatedly until Dimmer appears in the
display.
• Pressing
FUNCTION on the head unit also
performs the same operation.
2 Select DIM on or off with
E or e.
Pressing E or e will switch
Dimmer between
on and off and that status will be displayed (e.g.,
Dimmer :ON ).
• Pressing
5 or ∞ on the head unit also per-
forms the same operation.
Selecting the brightness
You can select the display brightness. Initially
this mode is set to 12.
1 Press F to select BRIGHT .
Press F repeatedly until Brightness appears in
the display.
• Pressing
FUNCTION on the head unit also
performs the same operation.
2 Select the desired brightness with
E or e.
• The display shows
0 – 15 .
• Pressing
5 or ∞ on the head unit also per-
forms the same operation.
Setting the rear output and sub-
woofer controller
This unit’s rear output (rear speaker leads out-
put) can be used for full-range speaker (
Rear
SP:FULL ) or subwoofer ( Rear SP:S.W ) connec-
tion. If you switch rear output setting to the Rear
SP:S.W , you can connect a rear speaker lead
directly to a subwoofer without using an auxil-
iary amp.
Initially, the unit is set for rear full-range speaker
connection (
Rear SP:FULL ).
When rear output are connected to full range
speakers (when
Rear SP:FULL is selected), you
can connect the RCA subwoofer output to a
subwoofer. In this case, you can select whether
to use the subwoofer controller’s (low pass
filter, phase) built-in
S.W Control:INT or the
auxiliary S.W Control:EXT .
Notes
• Even if you change this setting, there is no
output unless you switch the non fading out-
put (refer to page 60) or subwoofer output
(refer to page 59) in the audio menu on.
• If you change the subwoofer controller, sub-
woofer output and non fading output in the
audio menu return to the factory settings.
• Both rear speaker leads output and RCA rear
output are switched simultaneously in this
setting mode.
English
Español
Deutsch
F
rançais
Italiano
Nederlands
10
Section