FujiFilm FinePix E900 - Manual (Page 62)

BUSY
122 123
Warning Displays
eThe table below lists the warnings that are displayed on the LCD monitor.
(Lit red)
(Blinking red)
The batteries are low or completely out of
charge. Load new or fully charged batteries.
Warning Displayed Explanation Remedy
FOCUS ERROR
ZOOM ERROR
Camera malfunction or fault. i Turn the camera on again, taking care not to
touch the lens.
i Turn the camera off and on again. If the
message still appears, contact your FUJIFILM
dealer.
There is a strong likelihood of camera
shake because the shutter speed is slow. Use flash photography. However, use a tripod for
some scenes and modes.
The AF (autofocus) cannot work effectively. i If the image is too dark, take the picture at a
distance of around 2 m (6.6 ft.) from the subject.
i Use AF lock to take the picture.
Outside the AE continuous range. Aperture/Shutter speed display
(Lit red)
The picture can be taken, but the correct
brightness (exposure) will not be obtained.
NO CARD
No xD-Picture Card is inserted. Insert an xD-Picture Card.
i The xD-Picture Card is not formatted.
i The xD-Picture Card contact area is
soiled.
i Camera fault.
i Format the xD-Picture Card on the camera.
i Wipe the contact area on the xD-Picture Card
with a soft dry cloth. It may be necessary to
format the xD-Picture Card. If the message still
appears, replace the xD-Picture Card.
i Contact your FUJIFILM dealer.
CARD NOT INITIALIZED
CARD FULL
The xD-Picture Card is full. Erase some images or use an xD-Picture Card
that has ample free space.
CARD ERROR
i The xD-Picture Card contact area is
soiled.
i The xD-Picture Card format is incorrect.
i Camera fault.
i The xD-Picture Card is damaged.
i Wipe the contact area on the xD-Picture Card
with a soft dry cloth. It may be necessary to
format the xD-Picture Card. If the message still
appears, replace the xD-Picture Card.
i Contact your FUJIFILM dealer.
FRAME NO. FULL
The frame number has reached 999-9999. 1 Insert a formatted xD-Picture Card into the
camera.
2 Set “RENEW” as the FRAME NO. setting in
the SET-UP menu.
3 Start taking pictures (The frame numbers start
from “100-0001”)
4 Set “CONT.” as the FRAME NO. setting in the
SET-UP menu.
WRITE ERROR
i The data could not be recorded due to
an xD-Picture Card error or a
connection error between the xD-
Picture Card and camera.
i The image cannot be recorded as it is
too large to fit in the available space on
the xD-Picture Card.
i Re-insert the xD-Picture Card or turn the
camera off and then on again. If the message
still appears, contact your FUJIFILM dealer.
i Use a new xD-Picture Card.
READ ERROR
i The played back file was not recorded
correctly.
i The xD-Picture Card contact area is
soiled.
i Camera fault.
i An attempt was made to play back the
movie or the image that was not
recorded on this camera.
i These images cannot be played back.
i Wipe the contact area on the xD-Picture Card
with a soft dry cloth. It may be necessary to
format the xD-Picture Card. If the message still
appears, replace the xD-Picture Card.
i Contact your FUJIFILM dealer.
i The movie and image cannot be played back.
|
The timing for recording was incorrect
because the xD-Picture Card was
formatted on a PC. Use an xD-Picture Card that was formatted on
the camera.
` CAN NOT TRIM
≤ CAN NOT TRIM
An attempt was made to trim a 0.3M image
or an image shot using the RAW setting. The image cannot be trimmed.
Warning Displayed Explanation Remedy
PROTECTED FRAME
i A protected file was encountered.
i An attempt was made to add a voice
memo to a protected file.
i An attempt was made to rotate a
protected file.
i Protected files cannot be erased. Remove the
protection.
i Protected files cannot be added to voice
memos. Remove the protection.
i Protected files cannot be rotated. Remove the
protection.
DPOF FILE ERROR
Prints were specified for 1000 or more
frames in the DPOF frame settings. The maximum number of frames for which prints
can be specified on the same xD-Picture Card is
999.
Copy the images for which you want to order
prints onto another xD-Picture Card and then
specify the DPOF settings.
CAN NOT TRIM
i An attempt was made to trim an image
shot using a camera other than FinePix
E900.
i The image is damaged.
The image cannot be trimmed.
An attempt was made to specify DPOF
settings for an image that is not supported
by DPOF. DPOF printing cannot be used with this image
format. CAN NOT SET DPOF
r CAN NOT SET DPOF
≤ CAN NOT SET DPOF
An attempt was made to rotate a movie. These images cannot be rotated by image
formats.
r CAN NOT ROTATE
COMMUNICATION
ERROR
The camera is not connected to PC or
printer. i Check that the USB cable (mini-B) is connected
correctly.
i Check that your printer is turned on.
PRINTER ERROR
Displayed for PictBridge. i Check that the printer is not out of paper or out
of ink.
i Turn the printer off briefly and then turn it back
on.
i Refer to the user manual supplied with your
printer.
PRINTER ERROR
RESUME?
Displayed for PictBridge. Check that the printer is not out of paper or out of
ink. Printing automatically restarts when the error
is cleared. If the message still appears after
checking, press the “MENU/OK” button to restart
printing.
CANNOT BE PRINTED
Displayed for PictBridge.
i Refer to the user manual for the printer being
used and check whether the printer supports the
JFIF-JPEG or Exif-JPEG image format. If not,
the printer cannot print the images.
i Movies and images with CCD-RAW cannot be
printed.
i Was the image data photographed using
FinePix E900?
You may not be able to print some images
photographed on other cameras.
t ERROR i The voice memo file is faulty.
i Camera fault. i The voice memo cannot be played back.
i Contact your FUJIFILM dealer.
An attempt was made to show 5,000 or
more images by date sorting. No more than 4,999 images can be shown by
date sorting.
TOO MANY FRAMES