FujiFilm FinePix S3Pro - Manual (Page 18)

34 35
Basic
P
hotography
2
Single
Area AF
Dynamic
AF
TAKING PICTURES (P Auto-Multi Program)
6 Set the metering system selector dial to “/ ”
(Matrix metering).
● ! Matrix metering indication “ l ” appears in the viewfinder.
● ! When shooting with the camera held vertically, see the
section on vertical shooting (
➡P.36).
● ! Take care not to obscure the lens with your fingers or the
shoulder strap.
7 Set the Exposure mode dial to “P” (Auto-Multi
Program).
8 Brace your elbows against your body and hold the
camera with both hands.
9 Position the central focus area over the subject.
● ! If the subject is outside the focus area, either move the focus
area or take the picture using the AF Lock function (
➡P.40).
1 Set the focus mode selector switch to “S” (Single-
AF Servo).
2 1Press the “FUNC” button to display the AF
setting on the rear display panel.
2Press the “F1” button to select “7” Single area
AF.
● ! Make sure to turn the focus mode selector switch until it
clicks into position.
3 1 Unlock the 4-direction button.
2 Press “d ”, “c ”, “a ” or “b ” to position the
focusing area in the center.
4 Lock the 4-direction button to prevent accidental
improper use.
5 Hold down the release mode switch unlock button
and set the release mode switch to “,” (Single-
frame).
● ! The selected focus area indicator appears on the top display
panel, in the viewfinder display and on the viewfinder screen
(
➡P.47).
0 1 0 2
0 1
0 2
Continued