Philips DSR 300/00 - Manual (Page 32)

32 MENU
7.7.2 Add Service
This feature is used to search for new channels.
- Select Add Service from the Installation menu to access
the Add Service screen.
- Select values for the following:
• Port: up to 4 ports
Note: this item is used to configure the DiSEqC option
for multiple LNBs.
• Satellite: select the appropriate satellite using arrow
keys.
• Transponder: select a transponder to perform a search
for this particular transponder.
• Frequency: frequency value corresponding to the
selected transponder or entered manually using
numerical keys.
• Symbol Rate: symbol rate value corresponding to the
selected transponder or entered manually using
numerical keys.
• Polarization: Hor (horizontal) or Ver (vertical)
• Search options: select FTA to search for Free-To-Air
channels, or FTA+Scram… for Free-To-Air and
scrambled channels.
• Search type: select TP to perform the search for a
particular transponder, Network for a group of
transponders or 1 Sat for all the transponders of a
satellite.
Note: information about the selected satellite is displayed on the
right side of the screen.
7.7.3 Signal Test
This feature is used to test the signal strength and quality.
- Select Signal Test from the Installation menu to access the
Signal Test screen.
- Select values for the following:
• Antenna: select your antenna number
• Satellite: select the appropriate satellite using arrows
keys
• LNB Type: select your LNB type. If you use an universal
LNB, select Universal
• LNB Freq. 1: set automatically according to the satellite
and LNB Type selected. If you have a dual LNB, enter
the proper value in the value box.
English
Doc_DSR300.qxd 29/11/04 13:19 Page 32