Philips DSR 300/00 - Manual (Page 30)

30 MENU
To change the setting of your receiver:
- Press
y to scroll down to System Setting, and then press
to display the System Setting menu screen.
- Press y to scroll down to Remote Control Setting and
press .The Remote Control Setting screen appears,
indicating the current remote control setting value.
- Change the remote control setting value using
the u or i key:
• Either select 39 to control your receiver using the TV
remote control,
• Or select 40 or 38 to keep the remote control of your
receiver from interfering with other items of
equipment.
- Press to validate the remote control setting change
on the receiver. A pop-up message appears, prompting you
to refer to the user manual instructions to change the
setting of your remote control.You must change the
setting of your remote control to be able to proceed.
To change the setting of your remote control:
- Press number keys <1> and <3> simultaneously and hold
them for at least 5 seconds.
- Release these two keys.
- Enter the new setting according to the remote control
setting value displayed on screen within the next
60 seconds:
• Either press 1 to control your receiver using the TV
remote control (setting value 39),
• Or press 3 or 5 to keep the remote control of your
receiver from interfering with other items of
equipment (setting value 40 or 38 respectively).
- Press to confirm the remote control setting change
and return to normal operation.
Note: in case you find you cannot press , repeat steps 1 to
3 above.
- Press
Alternatively you may reset your remote control to its
default setting (40) by removing the batteries and reinserting
them after more than 3 minutes.
English
Doc_DSR300.qxd 29/11/04 13:19 Page 30