Pioneer SUPER TUNER AVIC-Z110BT - Manual (Page 9)

Information to User
This device complies with part 15 of the FCC
Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interfer-
ence, and (2) this device must accept any inter-
ference received, including interference that
may cause undesired operation.
Alteration or modifications carried out without
appropriate authorization may invalidate the
user
’s right to operate the equipment.
FCC ID : AJDK026
IC : 775E-K026
This device complies with Part 15 of FCC Rules
and RSS-Gen of IC Rules. Operation is subject
to the following two conditions: (1) this device
may not cause interference, and (2) this device
must accept any interference, including inter-
ference that may cause undesired operation of
this device.
MADE IN THAILAND
For Canadian model
This Class B digital apparatus complies with
Canadian ICES-003.
This transmitter must not be co-located or op-
erated in conjunction with any other antenna
or transmitter.
This equipment complies with FCC radiation
exposure limits set forth for uncontrolled
equipment and meets the FCC radio frequency
(RF) Exposure Guidelines in Supplement C to
OET65. This equipment has very low levels of
RF energy that it deemed to comply without
maximum permissive exposure evaluation
(MPE). But it is desirable that it should be in-
stalled and operated with at least 20cm and
more between the radiator and person
’s body
(excluding extremities: hands, wrists, feet and
ankles).
CAUTION:
USE OF CONTROL OR ADJUSTMENT OR PER-
FORMANCE OF PROCEDURES OTHER THAN
THOSE SPECIFIED HEREIN MAY RESULT IN
HAZARDOUS RADIATION EXPOSURE.
CAUTION:
THE USE OF OPTICAL INSTRUMENTS WITH
THIS PRODUCT WILL INCREASE EYE HA-
ZARD.
WARNING
Handling the cord on this product or cords asso-
ciated with accessories sold with the product will
expose you to chemicals listed on proposition 65
known to the State of California and other govern-
mental entities to cause cancer and birth defect
or other reproductive harm. Wash hands after
handling.
Introduction
En
9
Chapter
01
Introduction