Panasonic KX-FC241AL - Manual (Page 48)

5. Fax
46
5.4.3 Erasing a stored item from
the broadcast memory
1 Press {>}.
2 Press {A} or {B} repeatedly to display
“
”.
3 Press {MENU}.
4 Press {#}.
5 Press {A} or {B} repeatedly to display the
desired item you want to erase.
L To cancel erasing, press {STOP}.
6 Press {SET}.
7 Press {SET}.
L To erase other items, repeat steps 5 to 7.
8 Press {STOP}.
5.4.4 Sending the same
document to pre-programmed
parties
1 Insert the document FACE DOWN.
2 If necessary, press {A} or {B} repeatedly to
select the desired resolution (page 43).
3 Press {>}.
4 Press {A} or {B} repeatedly to display
“
”.
5 Press {FAX/START}.
L The document will be fed into the unit and
scanned into memory. The unit will then
send the data to each party, calling each
number sequentially.
L After transmission, the stored document
will be erased from memory
automatically, and the unit will
automatically print a report (Broadcast
sending report).
Note:
L If you select “ FINE”, “SUPER FINE” or
“ PHOTO” resolution, the number of pages
that the unit can send will decrease.
L If the document exceeds the memory
capacity, sending will be cancelled.
L If a party is busy or does not answer, it will be
skipped and redialled later up to 2 times.
To send the same document to a one-time
group of parties
You can also select a one-time group of parties
to send the same document to. After
transmission, this group will be deleted.
1. Insert the document.
2. Press {>}.
3. Press {A} or {B} repeatedly to display
“ ”.
4. Press {SET} to start programming the
parties you want to send the document to.
5. Press {A} or {B} repeatedly to display the
desired party.
6. Press {SET}.
L To program other parties, repeat steps 5
and 6 (up to 20 items).
7. Press {FAX/START} to start transmission to
the programmed parties.
To cancel broadcast transmission
1. Press {STOP} while “ BROADCASTING” is
displayed.
L The display will show “ SEND
CANCELLED?”.
2. Press {SET}.
FC243AL-PFQX2096ZA-en.book Page 46 Thursday, September 30, 2004 3:37 PM