Panasonic KX-FC241AL - Manual (Page 23)

2. Installation
21
Cordless Handset
2.5 Battery installation /
replacement
2.5.1 Installing the batteries
1 Insert the batteries negative (
−) terminal first.
2 Close the battery cover.
2.5.2 Replacing the batteries
If 7 flashes even when the batteries have
been fully charged, both batteries must be
replaced. Please use only Panasonic
batteries. See page 11 for accessory
information.
Important:
L Charge the new batteries for about 7
hours before initial use.
L When replacing the batteries, ensure that
the correct battery type is selected (page
77) even if you install the same type of
batteries.
L Use only rechargeable batteries. If you
install non-rechargeable batteries and
start charging, the batteries may leak
electrolyte.
L Do not mix old and new batteries.
1 Press the notch on the cover firmly and slide
it in the direction of the arrow.
2 Remove the batteries positive ( +) terminal
first. Replace both batteries. See the battery
installation procedure.
FC243AL-PFQX2096ZA-en.book Page 21 Thursday, September 30, 2004 3:37 PM