Lexmark 280 - Manual (Page 165)

If you see Ready on the printer display screen after you have replaced a photoconductor, follow Steps 1 through 7
below.
1 To specify the replaced photoconductor, press .
Supplies Menu appears.
2 Press .
Replace Supply appears.
3 Press .
4 Press the down arrow button until All, Cyan photoconductor, Magenta photoconductor,
Yellow photoconductor, or Black photoconductor appears, depending on the photoconductor
you just replaced.
5 Press .
photoconductor replaced appears.
Yes appears.
6 Press .
7 Press until Ready appears.
The task is complete.
Replacing a toner cartridge
When 88 Replace cartridge, 88 cartridge nearly low, or 88
cartridge low appears on the printer control panel, or when print becomes faded, try to extend the life of the
specified cartridge.
1 Open the front door.
Warning—Potential Damage: Make sure the printer is not open for 10 minutes or more to avoid overexposing
the photoconductor units to light.
Maintaining the printer
165