Lexmark 280 - Manual (Page 153)

56 Serial port disabled
• Press the down arrow button until Continue appears, and then press to clear the message.
The printer discards any data received through the serial port.
• Make sure the Serial Buffer menu item is not set to Disabled.
56 Standard USB port disabled
• Press the down arrow button until Continue appears, and then press to clear the message.
The printer discards any data received through the USB port.
• Make sure the USB Buffer menu item is not set to Disabled.
56 USB port disabled
• Press the down arrow button until Continue appears, and then press to clear the message.
The printer discards any data received through the USB port.
• Make sure the USB Buffer menu item is not set to Disabled.
57 Configuration change, held jobs were not restored
Press the down arrow button until Continue appears, and then press to clear the message.
58 Too many flash options installed
1 Turn the printer power off.
2 Unplug the power cord from the wall outlet.
3 Remove the excess flash memory.
4 Connect the power cord to a properly grounded outlet.
5 Turn the printer power back on.
58 Too many trays attached
1 Turn the printer power off.
2 Unplug the power cord from the wall outlet.
Note: Optional trays lock together when stacked. Remove stacked trays one at a time from the top down.
3 Remove the additional trays.
4 Connect the power cord to a properly grounded outlet.
5 Turn the printer power back on.
61 Remove defective hard disk
• Press the down arrow button until Continue appears, and then press to clear the message and continue
printing.
• Install a different hard disk before performing any operations that require a hard disk.
Understanding printer messages
153