Lochinvar ARMOR 151 - Manual (Page 21)

Installation & Operation Manual
21
3
General venting
(continued)
Table 3B Approved Stainless Steel Terminations and Adapters
Model
ProTech Heat Fab Z Flex
FasNSeal Saf-T Vent Z-Vent
**Adapter
Flue
Termination
Intake
Air
Termination
**Adapter
Intermediate
Adapter
Flue
Termination
Intake
Air
Termination
**Adapter
Flue
Termination
Intake Air
Termination
151 - 200 300715
FSBS3
FSRC3(R.C)
303889 KB80210 9353BUREZ-1*
9392
5300CI
9314TERM 2SVSLA03
2SVSTP03
2SVSRCX03
2SVSTEX0390
286-601 F303759
FSBS4
FSRC4(R.C)
FSAIH04
303888
KB285600 9454BUREZ-1*
9492
5400CI
9414TERM 2SVSLA04
2SVSTP04
2SVSRCX04
2SVSTEX0490
701-801
F303759
(Intake
Only)
FSBS6
FSAIH04
303888
* = This adapter must be used in addition to the water heater adapter for Saf-T vent pipe as shown in FIG. 3-12, unless approved
vent other than standard diameter is used. Consult a Heat Fab representative for questions.
**The stainless steel venting option is only available in 3" vent diameters.
Table 3C Stainless Steel Vent Termination Kit(s)
Model Kit Number
701 - 801 KIT3137
Stainless steel air intake/vent connections
1. Combustion Air Intake Connector (FIG.’s 3-12 thru
3-14) - Used to provide combustion air directly to the
unit from outdoors. A fitting is provided on the unit
for final connection. Combustion air piping must be
supported per guidelines listed in the National
Mechanical Code, Section 305, Table 305.4 or as local
codes dictate.
2. Vent Connector (FIG.’s 3-12 thru 3-14) - Used to
provide a passageway for conveying combustion
gases to the outside. A transition fitting is provided
on the unit for final connection. Vent piping must
be supported per the National Building Code,
Section 305, Table 305.4 or as local codes dictate.
Figure 3-12 Near Water Heater Stainless Steel Venting
Models 151 - 200
3" S.S. ADAPTER
VENT
3" S.S. INTERMEDIATE
(FOR SAF-T VENT ONLY)