Lexmark 4059-XXX User Manual
Page 95

Diagnostic Information
2-68
4059-XXX
The elevator tray does not move up or down. The printer
recognizes that the option is installed.
FRU
Action
1
Stepper Motor
High Capacity Feeder
Option Control Board
Stepper Motor Extension
Cable
Be sure the motor cable is correctly
installed at J1 on the high capacity
feeder system board. Be sure the
motor extension cable is properly
connected to the motor cable. Check
the cables for damage or loose
wires. Disconnect the motor and
check for a short between each pin
and the motor housing. If a problem
is found, replace the motor. Measure
the resistance between the following
pins on the motor cable connector:
Pins 1 (orange) and 3 (green)
Pins 2 (yellow) and 4 (white)
They measure between 10 and 15
ohms. If incorrect, replace the motor
assembly. If correct, replace the high
capacity feeder control board.
- E260d (142 pages)
- 6600 Series (173 pages)
- 10N0227 (1 page)
- Z12 (2 pages)
- 301 (144 pages)
- NO. 35 (1 page)
- Z65n (111 pages)
- dn2 (217 pages)
- 10E (144 pages)
- Z2300 (54 pages)
- 230 (213 pages)
- 310 Series (2 pages)
- PRO700 (24 pages)
- C 720 (18 pages)
- C520 (145 pages)
- X656 MFP (104 pages)
- Prospect Pro207 (27 pages)
- 337 (258 pages)
- OptraImage 242 (207 pages)
- T64x (6 pages)
- C524 (146 pages)
- 4098-001 (70 pages)
- 1200 Series (21 pages)
- X650 Series (8 pages)
- 5300 (179 pages)
- 302 (274 pages)
- 4549 (235 pages)
- 202 (320 pages)
- 4076-0XX (89 pages)
- 10N0016 (1 page)
- 5025 (171 pages)
- 1361760 (1 page)
- C 546dtn (6 pages)
- Interpret S400 (40 pages)
- x6575 (2 pages)
- 27S2156-001 (2 pages)
- MENUS AND MESSAGES C522 (55 pages)
- Z35 (101 pages)
- Z25 (24 pages)
- series x5100 (77 pages)
- Z82 (105 pages)
- 2500 Series (76 pages)
- 1200 (208 pages)
- Z33 (114 pages)
- 7600 Series (181 pages)