Linksys BUSINESS SPA922 - Manual (Page 50)

Linksys SPA9x2 Phone Administration Guide 43
Setting Optional Network Parameters
Setting System Features
6. Scroll to 9 Non-DHCP Subnet Mask. Press Edit, then enter the subnet mask of the phone
using the asterisk (*) in place of periods. For example, the IP address 255.255.255.0 would be
entered as 255*255*255*0. Press OK.
7. Scroll to 10 Non-DHCP Default Route. Press Edit, then enter the default gateway of the
phone using asterisks as shown above. Press OK.
8. Scroll to 11 Non-DHCP DNS 1. Press Edit, then enter the DNS1 of the phone using asterisks
as shown above. Press OK. Optionally scroll to 12 Non-DHCP DNS2.
9. Press the Save soft button.
NOTE: If you do not press Save, your changes are not applied. To cancel your changes, press
the Cancel softkey.
Setting Optional Network Parameters
Optional Network Configuration Notes
• HostName: Enter the host name of the SPA9x2 phone.
• Syslog Server: Enter the syslog server name and port. The syslog server logs SPA9x2
system information and critical events. If you enter both a Debug Server and a Syslog
Server, syslog messages are also logged to the debug server.
• Debug Server: Enter the debug server name and port. This feature specifies the server for
logging SPA9x2 debug information. The level of detailed output depends on the debug
level parameter setting (below).
• Debug Level: Enter a value from 0-3. The highest level, 3, is recommended because the
higher levels provide more debug information. To log SIP messages, you must set this
value to 2 or 3. To limit debug information, set this parameter to a low value such as 0 or
1. Defaults to 0.
• Primary NTP Server and Secondary NTP Server: Enter an IP address or hostname for the
NTP Server. The phones use these servers to synchronize its time. Defaults to blank.