Linksys BUSINESS SPA922 - Manual (Page 157)

Linksys SPA9x2 Phone Administration Guide
Cisco Confidential--First Draft
150
Regional Tab
SPA9x2 Phone Field Reference
Feature Dial Services Codes These codes tell the SPA9x2 what to do when the user is
listening to the first or second dial tone.
One or more *code can be configured into this
parameter, such as *72, or *72|*74|*67|*82, etc. Max total
length is 79 chars. This parameter applies when the user
has a dial tone (first or second dial tone). Enter *code
(and the following target number according to current
dial plan) entered at the dial tone triggers the SPA9x2 to
call the target number prepended by the *code. For
example, after user dials *72, the SPA9x2 plays a prompt
tone awaiting the user to enter a valid target number.
When a complete number is entered, the SPA9x2 sends a
INVITE to *72 as in a normal call. This
feature allows the proxy to process features like call
forward (*72) or BLock Caller ID (*67).
The *codes should not conflict with any of the other
vertical service codes internally processed by the
SPA9x2. You can empty the corresponding *code that
you do not want to SPA9x2 to process.
You can add a parameter to each *code in Features Dial
Services Codes to indicate what tone to play after the
*code is entered, such as *72‘c‘|*67‘p‘. Below are a list of
allowed tone parameters (note the use of back quotes
surrounding the parameter w/o spaces)
• c = Cfwd Dial Tone
• d = Dial Tone
• m = MWI Dial Tone
• o = Outside Dial Tone
• p = Prompt Dial Tone
• s = Second Dial Tone
• x = No tones are place, x is any digit not used
above
If no tone parameter is specified, the SPA9x2 plays
Prompt tone by default.
If the *code is not to be followed by a phone number,
such as *73 to cancel call forwarding, do not include it in
this parameter. In that case, simple add that *code in the
dial plan and the SPA9x2 send INVITE *73@..... as usual
when user dials *73.
Parameter Description