Lifescan SureStep Blood Glucose Monitor - Manual (Page 72)

SETTINGS
62
Canada and some European countries. If you
are not sure which unit of measurement to
use, check with your Healthcare Professional.
The mmol/L results include a decimal point
but mg/dL results do not.
To change the unit of measurement to
mmol/L, press the green
C button.
This symbol will flash on the display.
Press the blue power button to move to the
beep signals setting.
Beep Signals
The OneTouch ® SureStep ® Meter uses beep-
ing tones to signal certain steps in the proce-
dure. However, these “beep” signals do
not
mean that the step was performed correctly.
Three types of beep signals sound.
1. A single, short beep identifies each step
in the test procedure.
2. A single, long beep accompanies error
messages, a “
HI” result, and certain mis-
takes in doing the test procedure.
3. A three–tone beep sounds when the
meter displays a test result and when the
meter moves to the beep signal feature
in set–up mode.
DCO_05074503A_OT_SS_OB_US 6/19/03 11:59 AM Page 62