Resetting the configuration – Lindy Switch User Manual
Page 20
Resetting the configuration
The LINDY KVM IP asks for an unknown admin password
This may occur if the LINDY KVM IP has been previously configured. If the
existing admin password cannot be discovered, then your only recourse is to
perform a factory reset.
To invoke a configuration reset by switch
1 Remove power from the LINDY KVM IP unit.
2 At the rear of the LINDY KVM IP, adjacent to the power input socket, click
mini switch 1 to its ON (down) position.
3 Re-apply power to the LINDY KVM IP. On the locally connected monitor you
should see a Maintenance menu:
Maintenance
Reset Configuration
return to normal operation.
Configure Network
Put option switch 1 up to
To upgrade unit, visit:
http://192.168.42.154
IP Access Switch Plus Logon
Username:
<
Password:
4 Select the ‘Reset configuration’ option.
A warning screen will be displayed. Select the RESET option and press
.
5 Remove power, return the mini switch 1 to its OFF position and then re-
apply power. The locally connected monitor should display the first screen of
the
initial configuration sequence
The LINDY KVM IP does not display the configuration sequence
If the LINDY KVM IP has been previously configured it may not automatically
display the first of the setup screens. In this case you have two options, either:
• Access the Unit, Network and Serial
configuration screens separately
, or
• Reset the configuration:
To invoke a configuration reset by main menu
1 Using the locally connected keyboard and screen, log on as the admin user.
2 Select the ‘Configuration’ option.
Configuration
Reset Configuration
Back
Modem Configuration
Network Configuration
Unit Configuration
3 Highlight the ‘Reset configuration’ option and press
.
A warning screen will be displayed, select the RESET option and press
.
Reset Config
DO YOU WISH TO CONTINUE?
Cancel
RESET
WARNING: Continuing will cause
your existing configuration to
be erased.
The unit will then reset and
require re-configuring before
it can be used.
4 The LINDY KVM IP will reset and then display the first of the four
.