Linksys EtherFast FENSK05 v2 User Manual

Page 20

10/100 Network In a Box

Linksys EtherFast

Series

13. Click Finish. When asked if you want to restart your computer, remove

the Driver Disk and click Yes.

14. Once your PC has rebooted and you are logged in, double-click the

Network Neighborhood icon on your desktop. Ensure that you have
access to the network. If you do, your card has been properly installed.

• If you had previously installed any NT service packs, you must go back

and re-install those service packs now.

• If you need to install the TCP/IP protocol, refer to your system adminis-

trator or your Windows NT documentation. Linksys does not provide
technical support for the configuration or troubleshooting of the TCP/IP
protocol

The Windows NT Installation and Setup of the EtherFast 10/100 LAN

Card is complete. Do not continue on with the next set of instructions.

They are for NT users who already had their networking configured.

otte

e: If you had previously installed any NT service

packs, you must re-install them. Otherwise, you may
receive Not Enough Service Storage Space errors in
the Event Viewer.

11. NT will copy the necessary network

drivers to your PC. When the copying is
complete, you will see a list of installed
bindings. Change the bindings settings if
needed and click Next. Click Next
again.

12. Choose either Workgroup or Domain, depending on the type of network

you're setting up. (Your Microsoft documentation explains the difference
between Workgroups and Domains.) Click Next.

otte

e:: For information and help on

choosing your bindings, services
and protocols, ask your network
administrator, or check your
Windows NT documentation.