Linksys EtherFast FENSK05 v2 User Manual

Page 19

10/100 Network In a Box

Linksys EtherFast

Series

8. A list of services will appear. Click Next to approve these services, fol-

lowed by Next again.

9. NT will probably ask you to supply your original Windows NT CD-ROM

or setup disks. If so, place your Windows NT CD-ROM in your CD drive.
If the CD-ROM loads a pop-up window, close it. Type

D:\i386

(or the

appropriate CD-ROM drive letter) in the box and click Continue.

10. NT will ask you to choose a media type for the EtherFast card. Choose

AutoSense. You can change these settings later if needed. When finished,
click OK.

6. The adapter will be added to the list of installed Network Adapters. Click

Next.

7. Place

check marks beside each

listed network protocol that you
wish to install. See your
Microsoft Windows NT user
guide or talk to your network
administrator for more informa-
tion about network protocols.
When you're finished, click
Next.

otte

e:: If you install the T

P//IIP

P p

prro

otto

oll, refer

to your system administrator or your
Windows NT documentation when installa-
tion steps that aren’t listed in this User
Guide appear. Linksys does not provide
technical support for the configuration or
troubleshooting of the TCP/IP protocol.