Linksys EtherFast FENSK05 v2 - Manual (Page 16)

10/100 Network In a Box
27
Linksys EtherFast ® Series
26
3. The Install Hardware Device Drivers dialog box will appear. When
Ethernet Controller is displayed, select “Search for a suitable driver for your
device (Recommended)”. Click Next.
4. The Locate Driver Files dialog box will appear. Select “Specify a loca-
tion”. Click Next.
Windows 2000 Installation &
Setup
Overview
After physically installing the EtherFast 10/100
LAN Card in your computer, follow these
instructions to install the network driver. The
installation procedure for the network driver will
vary slightly depending on which version of
Windows 2000 you are using, and on your cur-
rent system configuration.
Installing the Driver in Windows 2000
After physically installing the EtherFast Card in your computer, follow these
instructions to install the network driver.
1. Start your computer if you haven’t already done so, and boot
Windows 2000. Log in with administrative rights if you are asked to.
2. Windows will display the Found New Hardware Wizard box. Click Next.
N No otte e:: Prior to
proceeding,
ensure that you
are operating
Windows 2000
with administrative rights. If
you log into Windows 2000
without administrative rights,
you may run into problems
during the installation.