Linksys PCMPC100 v3 - Manual (Page 20)

EtherFast ® 10/100 PC Cards
Windows 2000 Installation and
Setup
After physically installing the EtherFast PC Card in your computer, follow
these instructions to install the network driver.
1. Windows 2000 will automatically recognize your EtherFast PC Card.
2. Windows will then display the Found New Hardware Wizard Screen. Click
Next.
35
Instant EtherFast ® Series
8. Click on the Protocols tab.
Add any protocols you
require by clicking the
Add button.
9. After your bindings, set-
tings, and services are set,
click the Close button.
10 The Network Settings Change box will appear. Remove your Driver Disk
and click theYes button to restart your PC.
11. Once your PC has rebooted, double-click the Network Neighborhood icon
on your desktop. Make sure that you have access to the network. If you do,
you card has been properly installed.
The Windows NT EtherFast Card Installation and Setup is complete.
N No otte e: If you had previously installed any NT service packs, you must
re-install them.
34
Overview
N No otte e:: Screen shots used in this Installation and Setup section are
from installation of the standard EtherFast 10/100 PC Card
(PCMPC100 v3). If you are installing the EtherFast 10/100
Integrated PC Card (PCM100 v3), the installation process will be
unchanged, however, the product name will be different.
N No otte e:: If you install the
T TC CP P//IIP P p prro otto oc co oll, refer to
your system administra-
tor or your Windows NT
documentation when
installation steps that
aren’t listed in this User
Guide appear. Linksys
does not provide techni-
cal support for the con-
figuration or trou-
bleshooting of the
TCP/IP protocol.