Linksys PCMPC100 v3 - Manual (Page 15)

EtherFast ® 10/100 PC Cards
25
Windows NT 4.0 Installation and
Setup
The following instructions will set up an NT 4.0 server/workstation on your
PC. You should have your original Windows NT CD-ROM handy during the
installation, as you might be asked to supply it.
To install the network driver for an NT 4.0 Server or Workstation
1. Log into Windows NT as a network administrator.
2. Click on Start, Settings, Control Panel, and then double-click on the
Network icon.
3. If you have not previously installed Windows NT networking on your com-
puter, a message will appear that reads: Windows NT Networking is not
installed. Do you want to install it now?
• If you see this message, click Yes to install NT networking along with the
EtherFast Card's network driver, and continue with step 1 below.
• If you don't see this message, NT networking is already installed. Skip to
the section entitled Installing the EtherFast Network Driver if Networking
is Already Installed.
1. After clicking on Yes, the Network Setup Wizard window will appear.
2. Put a checkmark next to the Wired to the network option. Click Next.
Installing NT Networking & the EtherFast Card Driver
Overview
N No otte e:: Screen shots used in this Installation and Setup section are
from installation of the standard EtherFast 10/100 PC Card
(PCMPC100 v3). If you are installing the EtherFast 10/100
Integrated PC Card (PCM100 v3), the installation process will be
unchanged, however, the product name will be different.
Instant EtherFast ® Series
24
6. When the following window appears, click Finish. When you are asked if
you want to restart your computer, remove any Driver Disks from the flop-
py disk drive, click Yes, and allow your system to restart.
7. After Windows restarts, enter a User Name and a Password when
prompted, and click the OK button.
8. Once you are back on the Windows desktop, you can make the necessary
changes to your system’s network settings by clicking on the Start button,
then Settings, then Control Panel, then double-click the Network icon.
9. When the above window is displayed, click on the Configuration tab.
Confirm that all the following network components are installed:
• Client for Microsoft Networks
• Linksys EtherFast 10/100 PC Card (PCMPC100 V3)
• TCP/IP
To set up File and Printer Sharing, or to configure Client for Microsoft
Networks or Client for Netware Networks, please refer to the Appendix.
Your EtherFast card is now successfully set up.
N No otte e:: Linksys does
not provide technical
support for TCP/IP
configuration or trou-
bleshooting.