La-140 – mounting your radiator – Listen Technologies Stationary LA-350 User Manual
Page 82
76
LA-140
LT-82
Design GuideDesign Guide
LA-140
3
$WWDFK7LOW$UP´%µWR6ZLQJ$UPRIUDGLDWRUVZLQJDUPFRPHVDWWDFKHGWRUHDURIUDGLDWRUXVLQJLQFOXGHGPRXQWLQJ
hardware screws. The bottom hole in Swing Arm must be used for this install.
Attach Tilt Arm “B”
4
Determine correct angle setting to use for the radiator using the design guide, see page 13 of design guide.
Determine correct angle
5
$WWDFK5DGLDWRUWR'HVN0LF6WDQGXVLQJ7LOW$UP´$µDQG7LOW$UP´%µ8VHWKH7LOW%ROWWRIDVWHQWKHWLOWDUPVWRJHWKHU
ATTENTION: Note the angle measurements on Tilt Arm “B” and verify that the correct angle is selected
before fully tightening Tilt Bolt.
Attach Radiator to Desk/Mic Stand
6
Connect CAT-5 and Coaxial cables to appropriate locations on radiator.
Connect CAT-5 and Coaxial cables
LA-140 – Mounting your Radiator