Listen Technologies Stationary LA-350 - Manual (Page 68)

62
LA-140
LT-82
Design GuideDesign Guide
LA-140
3
$WWDFK7LOW$UP´%µWR6ZLQJ$UPRIUDGLDWRUVZLQJDUPFRPHVDWWDFKHGWRUHDURIUDGLDWRUXVLQJLQFOXGHG0RXQWLQJ
Hardware Screws. Any of the seven holes in Swing Arm can be used for this.
Attach Tilt Arm “B”
4
3XOO&$7DQG&RD[LDOFDEOHVWKURXJKKROHLQ:DOO%R[3ODWH
Pull CAT-5 and Coaxial cables through (if necessary)
5
Determine correct angle setting to use for the radiator using the design guide, see page 13 of design guide.
Determine correct angle
6
$WWDFK5DGLDWRUWR:DOO%R[3ODWHXVLQJ7LOW$UP´$µDQG7LOW$UP´%µ8VHWKH7LOW%ROWWRIDVWHQWKHWLOWDUPVWRJHWKHU
ATTENTION: Note the angle measurements on Tilt Arm “B” and verify that the correct angle is selected
before fully tightening Tilt Bolt.
Attach Radiator to Wall Box Plate
LA-140 – Mounting your Radiator