Listen Technologies Stationary LA-350 - Manual (Page 45)

39
LT-82
Design Guide Design Guide
LT-82
LT-82 Setup and Operating Instructions
5
The radiator(s) can be powered by either the transmitter Power Output or remotely with a power
supply (LA-205) near the radiator. If powering the radiator(s) with the transmitter, connect the
transmitter Power Output to the radiator Power Input with CAT-5 cable.
NOTE: A maximum of two radiators can be powered by each LT-82. It is important not to exceed
powering more than two radiators per transmitter or external power supply.
Connect LT-82 Power to Radiator(s)(if desired)
6
Powering the LT-82
ATTENTION: Do not connect the LT-82 power supply to an outlet until all other
power connections within the system have been made. This helps
to prevent power connection degradation.
RF Signal on
coaxial cable
radiator power on CAT-5 cable
6A
Plug the included power supply into the Power Input connection on the rear panel of the transmitter, and
then plug the power supply into an outlet.
Plug the included power supply into the Power Input connection
6B
Press the Power button on the front panel of transmitter(s) to turn the unit(s) on.
Press the Power button
%HVXUHWRSOXJLQWR/7
before connecting to
power outlet
RF Signal on
coaxial cable
radiator power on CAT-5 cable
TX power cable