Lantronix UDS1100 User Manual
Page 19
3: Getting Started
UDS1100 User Guide
19
Type
Non-configurable field. Displays the device type as UDS1100.
ID
Non-configurable field. Displays the UDS1100’s ID embedded
within the box.
Hardware Address
Non-configurable field. Displays the UDS1100’s hardware (or
MAC) address.
Firmware Version
Non-configurable field. Displays the firmware currently
installed on the UDS1100.
Extended Firmware
Version
Non-configurable field. Displays the full version nomenclature
of the firmware.
Online Status
Non-configurable field. Displays the UDS1100’s status as
online, offline, unreachable (the UDS1100 is on a different
subnet), or busy (the UDS1100 is currently performing a task).
Telnet Enabled
Non-configurable field. Permits Telnet sessions.
Telnet Port
Non-configurable field. Displays the UDS1100’s port for telnet
sessions.
Web Enabled
Non-configurable field. Permits configuration through Web-
Manager.
Web Port
Non-configurable field. Displays the UDS1100’s port for Web-
Manager configuration.
Maximum Baud Rate
Supported
Non-configurable field. Displays the UDS1100’s maximum
baud rate.
Note:
The UDS1100 may not currently be running at this rate.
Firmware Upgradeable
Non-configurable field. Displays True, indicating the
UDS1100’s firmware is upgradeable as newer version
become available.
IP Address
Non-configurable field. Displays the UDS1100’s current IP
address. To change the IP address, see
Number of COB partitions
supported
Non-configurable field. Displays the number of COB partitions
supported.
Supports Dynamic IP
Non-configurable field. Indicates whether the current IP
address on the UDS1100 was set manually or assigned by
DHCP.
Subnet Mask
Non-configurable field. Displays the UDS1100’s current
subnet mask. To change the subnet mask, see
Gateway
Non-configurable field. Displays the UDS1100’s current
gateway. To change the gateway, see
Number of Ports
Non-configurable field. Displays the number of ports on the
UDS1100.
TCP Keepalive
Non-configurable field. Displays the UDS1100’s TCP
keepalive value. The value is in the range 1-65s, and the
default setting is 45.