Lantronix UDS1100 User Manual
Page 15
3: Getting Started
UDS1100 User Guide
15
Figure 3-2. Standard UDS1100 Connected to Serial Device and Network
To install the unit:
Complete the following steps in order. Refer to the numbers in the figure above.
Note:
See the sections that follow for details about connectors and pinouts.
1. Connect a serial device to your unit.
2. Connect an Ethernet cable to the RJ45 port.
3. For the UDS1100-POE version, power is supplied to your unit over the Ethernet
interface using an 802.3af POE-compliant power source such as a POE mid-
span or POE Ethernet switch.
4. For non-POE UDS1100 unit, supply power to your unit using the power supply
that was included in the packaging.
Note:
The required input voltage for the non-POE UDS1100 is 9-30 VDC
(center +) or 10-24 VAC (1.5W maximum power required).
5. Supply power to the serial device.