Rear panel – KORG sampler User Manual
Page 14
6
17. Headphone jack
A set of headphones can be connected here (stereo 1/4"
jack).
This allows stereo monitoring of the same signal as the
OUTPUT L/MONO and R jacks.
18. Floppy disk drive
3.5 inch 2DD (double-side double-density) or 2HD (dou-
ble-side high-density) floppy disks can be inserted here,
allowing you to save your edited data, or to load factory-
set data, SMF data, or multisample/sample data, etc...
For details on handling floppy disks, refer to “Cautions
when handling floppy disks” (
Eject button
To remove a floppy disk, make sure that the disk access
indicator is dark, and then press this button. If the disk is
not ejected when you press this button, do not attempt to
forcibly remove the disk, but contact your Korg distribu-
tor.
19. CDRW-1 drive bay
The CDRW-1 (CD-R/RW drive) option can be installed in
this bay. (
☞PG p.286)
Rear panel
1. AC power supply connector
Connect the included power supply cable here.
After connecting the power supply cable to the TRITON
STUDIO, connect the other end to an AC outlet (
2. [POWER] switch
This switch turns the power on/off (
3. AUDIO OUTPUT
Connect these outputs to the input jacks of your amp or
mixer. In addition to the L/MONO and R main stereo
audio outputs, the TRITON STUDIO provides four indi-
vidual audio outputs. The sound from each oscillator,
drum, timbre/track, or insert effect can be freely routed to
any output (
☞p.139–).
(MAIN) L/MONO, R
These are unbalanced phone jacks.
These are the main audio output jacks. By setting “Bus
Select” to L/R, the output from an oscillator, an insert
effect, an individual drum part, or the metronome can be
output to the (MAIN) L/MONO and R jacks.
When making connections in stereo, use L/MONO and R.
When making connections in mono, use the L/MONO
jack.
(INDIVIDUAL) 1, 2, 3, 4
These are unbalanced phone jacks.
These are individual (independent) audio output jacks. By
setting the “Bus Select” to 1, 2, 3, 4, 1/2, or 3/4, an oscilla-
tor, an insert effect, an individual drum part, or the metro-
nome etc. can be assigned to be output from the
(INDIVIDUAL) 1, 2, 3, 4, jacks.
The output from the 1, 2, 3, 4 jacks is not affected by the
[VOLUME] slider.
4. AUDIO INPUT
These two audio inputs are used when recording a mono/
stereo sample from a mic or external audio source
(
☞p.37), or when applying the TRITON STUDIO’s inter-
nal effects to an external audio source (
The MIC/LINE level select switch ([MIC/LINE] switch)
and the level adjustment knob ([LEVEL] knob) allow you
to use a wide range of external audio sources, ranging
from mic level to line level.
AUDIO INPUT 1/2 jacks
These are unbalanced phone jacks.
[LEVEL] knob
This adjusts the input level of the AUDIO INPUT 1/2
jacks.
[MIC/LINE] switch
This switches the input level of the AUDIO INPUT 1/2
jacks.
18 19
17
Disk access
indicator
Eject button
1
2
3
4
5
6
11
7
9
8
10
12