Front and rear panel, Front panel – KORG sampler User Manual
Page 11
3
Introduction
Features
Front &
rear panel
LCD screen
Connections
Basics
Front and rear panel
Front panel
1. [SW1] key, [SW2] key
These keys are on/off switches, their function can be
assigned in Program, Combination, Sequencer, Song Play,
and Sampling modes. When on, the LED will light
(
2. Joystick
This controls pitch and modulation.
Move the joystick up/down and left/right (+Y, –Y, –X,
+X) to vary the effect (
Various program parameters and effect parameters will
determine what is being controlled by the joystick.
3. Ribbon controller
Slide your finger to the left or right on this ribbon control-
ler to control the pitch or modulation (
Various program parameters and effect parameters will
determine what is controlled by the ribbon controller.
4. [VOLUME] slider
This adjusts the volume that is output from the AUDIO
OUTPUT (MAIN) L/MONO, R jacks and the headphone
jack.
5. REALTIME CONTROLS
Use the [REALTIME CONTROLS] key to select A or B
mode for the realtime controllers, and use knobs [1]–[4] to
control the tone, effects, and MIDI control changes etc. in
realtime (
[REALTIME CONTROLS] key
This key selects either A or B mode for the realtime con-
trollers. The selected mode will light.
[1] knob, [2] knob, [3] knob, [4] knob
In A mode, the function of each knob is fixed. [1] is the
low pass filter cutoff frequency, [2] is the filter resonance
level or the cutoff frequency of the high pass filter, [3] is
the filter EG intensity, and [4] is the filter/amp release
time.
In B mode, each knob will control the function that was
assigned to it in the Program, Combination, Sequencer,
Song Play, or Sampling modes.
6. Mode keys
Use these keys to enter the desired mode.
When you press a key, the LED will light, and you will
enter the mode whose key you pressed (
[COMBI] key
Combination mode will be selected.
[PROG] key
Program mode will be selected.
[SEQ] key
Sequencer mode will be selected.
16
4
8
12
2
5
6
9
1
3
7
10 11
13
15
14
18 19
17