KORG sampler - Manual (Page 122)

114
• P0: Play/REC page
Song: 000, Meter: 4/4, Tempo: 120
• P0: Play/REC, Program T01–08 page
Track01 Program: INT-E101
• P5: Track Edit, Track Edit page
Track01: track data: 8 measures (D2–)
Press the SEQUENCER [START/STOP] key to start
playback.
As an example, set “ (Tempo)” to 100. Notice that the
pitch does not change when you play back at a differ-
ent tempo.
If the beat of the original rhythm loop sample is not
reproduced correctly when you change the tempo, or
if obtrusive noise is heard, this is because the sample
was not sliced appropriately in step 5. The way in
which the percussion instrument sounds were
divided will have a major impact on the quality of the
playback when the tempo is changed. You will need
to adjust the way in which the samples are divided in
step 5.
The silence between samples may become obtrusive
if you play back at a slower tempo, or noise may
occur between samples if you play back at a faster
tempo. To avoid such problems, you can set Stretch
“New BPM” or “Ratio” in step 6 to the tempo at
which you want to play back, and execute time
stretch to adjust the length of each sample. (
☞PG
p.112 9)
9 In “Song Select,” choose 001.
The following song data has been set/created automat-
ically as you specified in step 6.
• P0: Play/REC page
Song: 001, Meter: 4/4, Tempo: 120, RPPR: On
• P0: Play/REC, Program T01–08 page
Track01 Program: INT-E102
• P6: Pattern/RPPR, RPPR Setup page
Key: C#2, Assign: On,
Pattern: User, U00, Track: Track01
Pattern data: 1 measure (D2–)
In the P6: Pattern/RPPR, Pattern Edit page, press the
SEQUENCER [START/STOP] key to start playback of
pattern U00.
When you press the C#2 key in the P6: Pattern/RPPR,
RPPR Setup page, the RPPR function will start playing
pattern U00.
In the same way as in step 8, changing the playback
tempo will not affect the pitch.