Kenwood TH-G71E - Manual (Page 47)

41
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
MICROPHONE CONTROL
After connecting the optional SMC-33 or SMC-34
speaker microphone, you can change numerous
transceiver settings without using the transceiver keys or
controls. The 1, 2, and 3 keys located on the top of the
microphone are programmable with the transceiver key
(or key combination) function. The assigned default
functions are as follows:
[1]: Band select
[2]: VFO/ Memory Recall mode switch
[3]: Call channel recall (TH-G71E: Transmit power
select)
Note:
◆ Turn OFF the transceiver power before connecting the optional
speaker microphone.
◆ If the LOCK switch located on the rear of the microphone is ON, you
cannot re-program the Programmable Function keys.
1 Press one of the following key combinations
depending on which key you want to re-program:
Mic [1]+ POWER ON (“PF 1” appears)
Mic [2]+ POWER ON (“PF 2” appears)
Mic [3]+ POWER ON (“PF 3” appears)
2 Press a key or key combination on the transceiver
that you want to assign.
• To assign the Up function, rotate the Tuning control
clockwise. To assign the Down function, rotate the
Tuning control counterclockwise.
• Pressing the PTT switch assigns the VFO/MR switch.
• Pressing [0] to [9] allows you to recall a memory
channel number 0 to 9.
• You can assign the following key combinations:
Press [F], then press
[LAMP]
Lamp Latch
ON/OFF
[8]
Priority Scan
ON/OFF
[BAND]
Menu mode
select
[9]
Tone frequency
select
[LOW] Tone ON/OFF [0]
Memory Channel
Lockout ON/OFF
[1]
Squelch level
select
[VFO]
Memory ➡ VFO
transfer
[4]
Memory name
store
[MR]
Memory channel
store
[5]
Memory name/
frequency change
[CALL]
Call channel
store
[6] CTCSS ON/OFF [MHz]
Frequency step
size select
[7]
Tone Alert
ON/OFF
[REV]
Offset direction
select