Kenwood TH-G71E - Manual (Page 28)

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
22
MEMORY
➡ VFO TRANSFERS
Transferring the contents of a memory channel or the
Call channel to the VFO can be useful if you want to
search for other stations or a clear frequency, near the
selected memory channel or Call channel frequency.
1 Recall the desired memory channel or the Call
channel.
2 Press [F], [VFO].
• The entire contents of the memory channel or the Call
channel are copied to the VFO. VFO mode is selected
after the transfer is completed.
Note:
◆ A transmit frequency from an odd-split memory channel or odd-split
Call channel is not transferred to the VFO. To transfer a transmit
frequency, press [REV], then press [F], [VFO].
◆ Lockout status and memory names are not copied from a memory
channel to the VFO.
◆ If you recall the Call channel in step 1, simply turning the Tuning
control also transfers the contents to the VFO. The frequency,
however, is changed by one step.
CHANNEL DISPLAY FUNCTION
When this function is switched ON, the transceiver
displays only a memory channel number instead of a
frequency.
Press [BAND]+ POWER ON to switch this function ON
(or OFF).
When in Channel Display mode, you cannot use the
following functions:
• Band Select • VFO Select
• Call Channel Recall • Memory Channel Store
• Memory Name Store • Memory Channel Clear
• Memory
➡ VFO Transfer
• Memory Name/ Frequency
Display Switch
• Call Channel Store • Priority Scan
• Call/ Memory Scan • Partial/ Full Reset
Note:
◆ You cannot switch this function ON if you have stored frequencies in
no memory channels.
◆ When in Channel Display mode, you may want to recall only memory
channels of the desired band. Before pressing [BAND]+ POWER
ON
, select “ONE” in Menu No. 2 (MR), then select the desired band.
2
1