Kenwood TH-G71E - Manual (Page 37)

31
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
■ Selecting Priority Scan Method
This transceiver prepares the following two modes for
Priority Scan. Use mode B when you do not want
Priority Scan to disrupt your current QSO.
Mode A: Monitors the Priority channel every 3 seconds no
matter whether or not signals are being received
on the current operating frequency.
Mode B: Monitors the Priority channel every 3 seconds
only when no signals are present on the current
operating frequency.
1 Press [F], [BAND] to enter Menu mode.
2 Select Menu No. 11 (PRI).
3 Press [BAND] to select mode A (default) or mode
B.
4 Press any key other than [BAND], [LAMP], and
[MONI] to exit Menu mode.
■ Using Priority Scan
1 Press [F], [8] to activate Priority Scan.
• “PRI” appears.
• When signals are received on the Priority channel, a
beep sounds and the Priority channel frequency
appears. In addition, “Pr” appears and blinks.
2 Press the PTT switch to transmit on the Priority
channel and release the PTT switch to receive.
• Approximately 3 seconds after signals drop, Priority
Scan resumes.
3 To quit Priority Scan, press [F], [8] again.
Note:
◆ When signals are received on the Priority channel programmed
with CTCSS, the Priority channel is recalled; however, the
squelch does not open unless the signals contain the matching
CTCSS tone.
◆ You can simultaneously use Priority Scan and any other type of
Scan; however Priority Scan does not function while the other
scan is being paused.
◆ Pressing and holding [MONI] while using Priority Scan allows
you to monitor the current operating frequency; releasing [MONI]
resumes Priority Scan.
1
2