Kenwood TH-G71E - Manual (Page 24)

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
18
7 Press [MR].
• The selected frequency and related data are stored in
the memory channel.
• If the memory channel selected in the previous step
already contained data, the new data overwrites the
previous data.
STORING ODD-SPLIT REPEATER FREQUENCIES
Some repeaters use a receive and transmit frequency
pair with a non-standard offset. To access those
repeaters, it is necessary to store two separate
frequencies in a single memory channel. The following
steps will allow you to operate on those repeaters
without having to alter the offset programming in the
Menu.
1 Store the appropriate receive frequency by using
steps 1 to 7 given for simplex or standard repeater
frequencies.
• If necessary, select Tone ON {page 14} and tone
frequency {page 14}.
2 Select the appropriate transmit frequency.
3 Press [F].
4 Within 10 seconds, turn the Tuning control to select
the same memory channel that you selected in step 1
above.
5 Press [PTT]+[MR].
• The selected transmit frequency is stored in the memory
channel.
Note:
◆ When you recall an odd-split memory channel, “+” and “–” appear on
the display. To confirm the transmit frequency, press [REV].
◆ Transmit Offset status and Reverse status are not stored in an odd-
split memory channel.
STORING SIMPLEX FREQUENCIES OR STANDARD
REPEATER FREQUENCIES
1 Press [VFO] to select VFO mode.
2 Press [BAND] to select the desired band.
3 Turn the Tuning control to select the desired
frequency.
• You can also enter digits directly from the keypad. See
“KEYPAD DIRECT ENTRY” {page 40}.
4 If storing a standard repeater frequency, select the
following data:
Offset direction {page 13}
Tone ON, if necessary {page 14}
Tone frequency, if necessary {page 14}
• If storing a simplex frequency, you may select other
related data (CTCSS ON, CTCSS freq., etc.)
5 Press [F].
• A memory channel number appears on the right and
blinks.
• A triangle icon appears below the memory channel
number if the channel already contains data.
6 Within 10 seconds, turn the Tuning control to select
the desired memory channel.