Kenwood TH-G71E - Manual (Page 42)

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
36
TRANSMITTING STORED DTMF NUMBERS
To transmit a stored DTMF number, follow the procedure
below.
1 Press [PTT]+[BAND].
• The first 4 DTMF digits of the channel used last and the
channel number appear.
2 Release only [BAND], then press [0] to [9] to select
the desired channel.
• The number stored in the channel scrolls across the
display accompanied by DTMF tones from the speaker.
• After the transmission, the frequency display is restored.
Note: In step 2 you may forget the channel number you should select.
After releasing only [BAND], turn the Tuning control to find the desired
channel, then press [BAND] again. While turning the Tuning control,
you will confirm the first 4 digits stored in each channel.
2
1