Kenwood TH-G71E - Manual (Page 27)

21
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
■ Changing Call Channel Contents
1 Select the desired band.
2 Select the desired frequency and related data
(Tone, CTCSS, etc.) using VFO mode or Memory
Recall {page 19}.
• When you program the Call channel as an odd-split
channel, select a receive frequency.
3 Press [F], [CALL].
• The selected frequency and related data are stored
in the Call channel.
• The previous mode is restored.
To also store a transmit frequency, proceed to the
next step.
4 Select the desired transmit frequency.
5 Press [F].
6 Press [PTT]+[CALL].
• The selected transmit frequency is stored in the Call
channel, and the previous mode is restored.
Note:
◆ Transmit Offset status and Reverse status are not stored in an
odd-split Call channel.
◆ Lockout status and memory names are not copied from a
memory channel to the Call channel.
◆ To store data other than frequencies, select the data in step 2,
not step 4.
CALL CHANNEL
The Call channel can be used to store any frequency
and related data that you will recall often. The Call
channel also can be programmed either as a
simplex&repeater or odd-split channel. No matter what
mode the transceiver is in, the Call channel can always
be selected quickly. You may want to dedicate the Call
channel as an emergency channel within your group. In
this case, the Call/VFO scan {page 29} will be useful.
The default frequency stored in the Call channel is
shown below:
The contents of the Call channel cannot be deleted;
however, you can overwrite old data with new data as
described in the following section.
■ Recalling the Call Channel
1 Select the desired band.
2 Press [CALL] to recall the Call channel.
• “C” appears.
• To restore the previous mode, press [CALL] again.
VHF Version UHF
144.000 MHz 430.000 MHz Europe/ General
U.S.A./ Canada 144.000 MHz 440.000 MHz