Kenwood DV-6050 - Manual (Page 62)

62
Chapter 7: Other Information
Other Information
Remote control with the remote is impossible.
¶ The batteries are exhausted.
¶ The controller position is too apart from the remote
sensor, the control angle is deviated or there is an
obstacle between the remote and remote
sensor.
!
An inhibition icon is displayed and no operation is
accepted.
¶ The operations of certain DVDs and VCDs are
restricted by the intention of the software producers.
Such discs should be operated in accordance with the
software. Operations may also be restricted depending
on the player status.
DVD playback cannot be stopped by pressing the
STOP button.
¶ With certain DVDs, the inhibition icon is displayed
and playback cannot be stopped even when the 7
button is pressed. In this case, press the DISC SKIP
button to select another disc then press the
7 button
to stop playback.
If there is only one disc in the tray, open the tray, place
another disc, close the tray, press the DISC SKIP
button to select the second disc, then press the
7
button to stop playback.
Error code "E0102" is shown in the display and no
operation is accepted.
¶ Up to 5 discs can be placed in the tray of the player.
If you set a 6th disc by rotating the tray manually
during playback while 5 discs have already been
placed in the player, the player detects an error and
the display shows error code "E0102" at the moment
you attempt close the tray.
In this case, turn the player off, remove one of the
discs, then turn the player on again.
When an error code ("E" and 4 digits) is displayed in
other cases, always turn the player off then on again.
If the error code does not disappear after this, press
the POWER ON/OFF button while holding the
7
button on the player depressed. When the display
shows "INIT OK", turn the player on again.
O
If the error code still remains in the display, note the
error code and consult your dealer or local
KENWOOD for servicing.
The display shows "LOCKED" and no operation is
accepted.
¶ When the display shows "LOCKED" and the player
cannot be set to the standby mode or the disc tray
cannot be opened, perform the following procedure.
While holding the 7 button on the player main unit,
press the POWER on the remote.
A MP3 disc cannot be played back.
¶ Certain MP3 discs are unplayable on this player.
An erroneous character is displayed in the title
display.
¶ The displayed characters may become erroneous if the
disc has been created on a PC, etc.