Kenwood DV-6050 - Manual (Page 51)

51
Chapter 6: Various Setups
V
arious Setups
Table : "Speaker Setting (Custom)" Function & Setting (2/2)
Level
Off
Icon Speaker Icon Function
Initial
Position Means
Subwoofer SW
Size
Subwoofer channel
output ON/OFF
On
Icon
––
Speaker Item Setting Item
Set the volume level –– 0 to -12 dB
÷ For the "Speaker Setting" when an AV amplifier
is connected digitally to the player, refer to the
instruction manual of the AV amplifier.
÷ Note on the Speaker Level adjustment.
When a set of speaker(s) is installed, it is
recommended to adjust the level using the Test
Tone.
W
÷ " " : Select to return to the previous screen.
4. Select the Speaker item (refer to the table on the right)
and press the ENTER button.
Select the Function item (refer to the table on the
right) and press the ENTER button.
Select the Setting item (refer to the table on the right)
and press the ENTER button.
÷ When setting the distance of each speaker, place
the cursor on the nearest integral value among "0"
to "10", then press the ENTER button and adjust
the distance using the cursor up/down button. After
setting the distance, press the ENTER button again.
dB
Speaker Setting (Custom)
-12 -11 -10 -9 -8 -7 -6 -5 -4 -3 -2 -1 0
ft 0 10 20 30
C
Level
Distance
Exit
Off Size Normal Large
0 dB
10 ft
0 dB
10 ft
0 dB
10 ft
5 ft 0 dB 0 dB LS
R
RS
L
SW
C
0 dB
Press the cursor button to select "Exit", then press
the ENTER button.
5. Repeat step 4 as required.
6. Press the cursor button to select "Exit", then press
the ENTER button.
0 dB
On
Select "Off" if the subwoofer is
not used.