Kenwood C-V751 - Manual (Page 24)

24
Speaker settings
7 Set the center speaker size. “CNTR (C)”
8 Select Lrg, Nml or Off.
÷ When “SW” is set to ON and “L/R” is set to “Nml”, “C” and “LS/RS”
are set to automatically “Nml”.
(Select the icon)
C Lrg : A large center speaker is connected to the AV
control center.
C Nml : An average size center speaker is connected to the
AV control center.
C Off : No center speaker is connected to the AV control
center.
3 Set up the subwoofer remix. “Remix”
4 Select On or Off.
5 Set up the front speaker size. “FRNT (L/
R)”
(Select the icon)
Each press changes the setup.
6 Select Nml or Lrg.
L/R Nml (normal)
: Average size front speakers are connected to the AV control
center.
L/R Lrg (large)
: Large front speakers are connected to the AV control center.
Each press changes the setup.
SW Remix On : Subwoofer remix on
SW Remix Off : Subwoofer remix off
÷ This setting is not available if “SW Off” is selected in the above.
÷ Only the Custom setup can be set.
÷ If you selected “On” for the subwoofer, all of the bass below 80Hz
is removed from other speakers in your system and is sent to the
subwoofer in all listening modes.
1 Set up the subwoofer. “SW”
(Select the icon)
Select a speaker system.
2
÷ When the setting "SW Off" is selected, the front speakers automati-
cally are set to "Lrg" and the procedure skips to step 7.
2 Select On or Off.
Each press changes the setup.
SW On : Subwoofer on
SW Off : Subwoofer off
9 Set the surround speaker size.“SURR (LS/
RS)”
0 Select Lrg, Nml or Off.
(Select the icon)
LS/RS Lrg : Large surround speakers are connected to the AV
control center.
LS/RS Nml : Average size surround speakers are connected to
the AV control center.
LS/RS Off : No surround speakers are connected to the AV
control center.
÷ When “C” is set to “Nml” or Off, “LS/RS” is automatically set to
“Nml” or Off.
(Select the icon)
! Select the “Enter” icon.
@ Select the “Next” icon.
SW Yes : Subwoofer on
SW No : Subwoofer off
Quick setup
Custom setup
or
or
GRC GRC
÷ When “SW” is set to ON and “L/R” is set to “Nml”, “C” and “LS/RS”
are set to automatically “Nml”.