KORG Speaker System - Manual (Page 38)

34
Simple program editing
Program sounds can be modified and created in Pro-
gram P1: Edit-Basic–P9: Edit-Master Effect. However,
you can also use the “Performance Editor” to perform
simple editing in Program P0: Play as well.
You can also use REALTIME CONTROLS [1]–[4] knobs
to modify the sound.
The sound that you edit using the Performance
Editor or using REALTIME CONTROLS knobs
[1]–[4] in A-mode (or B-mode if CC#70–79 are
assigned) can be saved by writing the program.
If you wish to keep the edited sound, you must
write the program before selecting another pro-
gram or turning off the power (
☞ p.38).
1 Press the [PROG] key to enter Program mode.
2 Press the Performance Edit tab.
By using the eight sliders of the Performance Editor,
you can make overall adjustments to the sound.
When you move a slider, multiple program parame-
ters are adjusted simultaneously.
Depending on the settings of the program parame-
ters, the result may not be noticeable.
Octave
Adjust the octave.
Pitch Stretch
Simultaneously adjust the transpose and tune settings
of the oscillator. This allows you to produce a variety
of tonal changes without losing the character of the
original sound.
This Performance Edit function cannot be used on
bank F.
OSC Balance
Adjust the level balance between oscillators 1 and 2.
For programs whose “Oscillator Mode” (Program
P1: Program Basic tab) setting is Single, oscillator
2 will not sound. Only the level of oscillator 1 will
change. For a Drums program, this performance
editor will have no effect.
Amp Level
Adjust the amp level. This will adjust the volume of
the entire program.
Attack Time
Adjust the attack time of the filter EG and amp EG.
This will adjust the speed of the attack from note-on.
In order to maximize the effect of the Attack Time
adjustment, the amp EG Start Level, Attack Level,
Start Level Modulation, and Attack Time Modula-
tion parameters are also adjusted.
Decay Time
Adjust the decay time and slope time of the filter EG
and amp EG.
IFX Balance
This simultaneously adjusts the “Wet/Dry” balance of
all insert effects 1–5. The type of each insert effect is
shown in the LCD screen.
MFX Balance
This simultaneously adjusts the Return 1 and 2 param-
eters of the master effects. The type of each master
effect is shown in the LCD screen.
These can be used to edit parameters such as the filter
cutoff frequency, resonance, the amp and filter EG, vol-
ume, portamento time, pan, pitch LFO, and master
effect send level etc. (
☞ p.26).
Performance Edit
Parameters assigned to B-mode
of the realtime editor
Performance
editor
Type of Insert
effect
Functions
assigned to
[SW1] and
[SW2] keys
Type of
Master effect
Realtime controls