Kenwood HM-382MD - Manual (Page 43)

Application section
43
Start recording.
2
3
○
○
○
○
○○○○○○○○○○○○○○○○○○○○
MD O.T.E.
TAPE O.T.E.
1
menu
down
volume/
multi control
up
set/demo
Program recording
(CD
=
MD / CD
=
TAPE / TWIN REC)
Desired CD tracks can be programmed in the desired sequence and recorded onto an MD or tape.
Convenient Recording Methods
Be sure to put the MD recorder and cassette deck in stop mode.
Program the desired sequence of CD
tracks.
Make the preparations for recording.
CD
=
MD / CD
=
TAPE TWIN REC
Perform steps 1 and 2 of the procedure in
”Listening in the desired sequence (Program
playback)”.
¤
÷ When the PGM/AUTO/MONO key is pressed to cancel
the edited contents, the entire editing contents will be
erased.
¤
÷ Tracks programmed beyond the available MD or tape
recording time will be interrupted in the middle.
To interrupt a recording
( Recording and playback will be
stopped.)
1 Select ”REC MODE ?” then
”TWIN REC ?”.
2 Start recording.
At the end of the recording
MD recorder : Stop.
Cassette deck : Stop is executed after an unre-
corded portion of about 4 sec. has
been produced.
or
1 MD : Insert a disc into the MD recorder.
TAPE : Perform steps 1 to 3 of the procedure
in ”Recording on TAPE”.
º
2 Insert disc in the CD player.
Note that this cassette deck cannot record onto
Metal tapes.
Note Note
Do not turn power off or apply shock or impact while
"WRITING" is displayed. If the power cord is un-
plugged before "WRITING" disappears, the recorded
or edited data will be lost.
STOP