Kenwood HM-382MD - Manual (Page 41)

Application section
41
3
1
○○○○○
○
○
○
○
2
○○○○○○
○○○○○
STOP
MD O.T.E. TAPE O.T.E.
Convenient Recording Methods
One-touch edit recording
(CD
=
MD /CD
=
TAPE)
Records all tracks in a CD with a simple operation. (All-track recording)
Records a single CD track being played from the beginning. (Single-track recording)
Be sure to put the MD recorder and cassette deck in stop mode
CD
=
MD
1 Insert a disc into the MD recorder.
2 Insert disc in the CD player.
Make the preparations for recording.
1 Perform steps 1 to 3 of the procedure in
”Recording on TAPE”.
º
2 Insert disc in the CD player.
CD
=
TAPE
Check the current play mode of the CD player.
Start recording.
All-track recording Single-track recording
If it is in play mode, stop it. Select the desired CD track and play it. &
To record other tracks, repeat steps
2 and
3 for each track.
To interrupt a recording
(Recording and playback will be
stopped.)
At the end of the recording
MD recorder : Stop.
Cassette deck : Stop is executed after an unre-
corded portion of about 4 sec. has
been produced.
÷ When the MD O.T.E. or TAPE O.T.E. key is pressed for ”Single-track recording”, the CD track being played is replayed
from the beginning and recording start at the same time.
÷ The recording operation can also be controlled from the main unit, by setting "REC MODE" to "CD = = = = = MD" or
"CD
= = = = = TAPE".
Note that this cassette deck cannot record onto
Metal tapes.
Note Note
Do not turn power off or apply shock or impact while
"WRITING" is displayed. If the power cord is un-
plugged before "WRITING" disappears, the recorded
or edited data will be lost.
STOP