Kenwood HM-382MD - Manual (Page 22)

Basic section
22
1 1
2 2
TAPE
0
1 1
Playback of tape
If you load a tape in the cassette deck in advance while
the power is off. pressing the TAPE
23 key turns power
on automatically and starts the tape playback.
To stop playback
Selection of TAPE EQ.
Selection of reverse mode To wind tape at high speed
Start playback
To wind tape at high
speed
To stop playback
1. Load a cassette tape.
1 Press the TAPE 0 key.
2 Insert a tape.
3 Press the TAPE 0 key.
Start playback
2. Start playback.
During playback, the tape running direction changes each time the
key is pressed.
Indicates the tape transport direction during playback or recording by
lighting of
2 or 3. This direction is the direction stored in memory when
the tape was last stopped.
Transport direction indicators
Transport direction indicators
TAPE
2 3
2 2