Operation in graphic mode, 2 5 k h z – Kenwood G-EQ300 User Manual

Page 17

G-EQ300 (En/K)

1 7

Select the “graphic equalizer display mode”.

Select the “EQ.ON” mode.

Select the “GRAPHIC” mode.

Select the frequency band to be adjusted.

Adjust its level.

EQ. ON

“EQ. ON” lights up.

2 5 K H Z

2.5k

3.9k

6.3k

1.5k

Fine adjustment of each frequency band:

If the mode is switched from “GRAPHIC” to “PARAMETRIC”, the equalizer pattern created in the GRAPHIC mode is cleared.

This mode allows to adjust the equalizer curve for each
frequency band provided. The curve created in the param-
eter mode can be fine-adjusted in this mode.

Creation of desired equalizer patterns

Operation in GRAPHIC mode

“GRAPHIC” lights up.

GRAPHIC

Repeat steps

4 and 5 above.

Each press switches the display modes as follows.

1 Graphic equalizer display mode
2 Spectrum analyzer display mode
3 DEMO(Demonstration) mode

Each press switches the display as follows.

1 GRAPHIC

: Mode for adjusting equalizer curves.

2 PARAMETRIC: Mode for creating a curve according

to center frequencies.

Note

GRAPHIC/
PARAMETRIC

FREQUENCY JOG

EQ.LEVEL

DISPLAY

EQ.EFFECT