Kenwood KRF-V9300D - Manual (Page 33)

English
33
Set
u
p
5
Continue the measurement.
7 If a confirmation message (fi) is displayed:
Use [MULTI CONTROL
3] to select "Continue".
[ENTER]
7
If an error message ( ›) is displayed:
Use [MULTI CONTROL 3] to select "Retry".
[ENTER]
The measurement starts again.
6
Auto Setup completes.
The display changes from "Analyzing" to "Complete" when
Auto Setup completes.
When "Confirm" is displayed, pressing the [ENTER] key
makes it possible to confirm the measurement data. (See
‹.)
Use [MULTI CONTROL 2/3] to select "Return".
[ENTER]
• Certain listening room properties may cause errors in the results
of measurements of the speaker levels and distances. In this case,
set up the unit again using "Manual Setup". (See –"Manual Setup"–>
fl.)
• If the speakers or speaker placement have changed after auto
setup, perform the auto setup again.
To confirm the measurement data
1
Select "Confirm" and press [ENTER] in step 3.
2
Use [MULTI CONTROL 2/3] to select the item to be
confirmed and press [ENTER]. And then use [MULTI
CONTROL
2/3] to confirm its data.
The following setting data can be confirmed.
– Speaker configuration ("SP Setup")
– Speaker levels ("SP Level")
– Speaker distances ("SP Distance")
– Crossover frequency ("Crossover")
For details on the setting items, see –"Manual Setup"–>
fl.
To cancel measurement in the middle
Any of the following operations will stop the measurement in the
middle and returns the display to the normal input display.
• Power ON/OFF
• Pressing the [AUTO ROOM EQ] key
• Press the [SETUP] key
• Pressing the [INPUT SELECTOR] key