Kenwood XXV-01D - Manual (Page 41)

English | 41
In Standby mode
Display-reversing Setting
If no operation is performed for a predetermined
period of time, switching between negative and
positive display modes takes place automatically.
Display-reversing maintains the initial brightness
of the display for a long period of time.
Display Setting
"Display N/P: Auto" Auto reverse display
"Display N/P: POSI" Positive display only
• Switching between negative and positive display may
not take place depending on the displayed mode.
In Standby mode
Built-in Amp Setting
Controlling the built-in amplifier.
Turning OFF this control enhances the preout
quality.
Display Setting
"AMP: ON" The built-in amplifier activates.
"AMP: OFF" The built-in amplifier deactivates.
In Standby mode
G-Counter Level set
Calibrating G-Point. Setting the level according to
the kinds of vehicles.
Display Setting
"G-Counter: Level 1" Counter is easy to go up.
"G-Counter: Level 2" …
"G-Counter: Level 3" Counter is hard to go up.
• In the case of driving situations calling for few
accelerations, set the G-Point up to "G-Counter: Level
1". In the case of frequent accelerations, set it up to "G-
Counter: Level 3".
In Standby mode
G-Analyzer Reset
Resets the value of G-Meter and G-Counter.
1 Select G-Analyzer Reset mode
Push the Control knob towards [ 4] or
[ ¢].
Select the "G-Reset" display.
2 Enter G-Analyzer Reset mode
Press the Control knob for at least 1 second.
3 Select the Reset item
Push the Control knob towards [FM] or [AM].
"G-Meter Reset": Reset the value of G-Meter.
"G-Counter Reset": Reset the value of G-Counter.
4 Reset the value
Press the Control knob for at least 2 seconds.
"Reset OK" is displayed.
5 Exit G-Analyzer Reset mode
Press the [MENU] button.