General features, Sound field control 1 – Kenwood XXV-01D User Manual
Page 12
12
|
English
General features
Sound Field Control
1
Select the source to adjust
Press the [SRC] button.
2
Show the Multi-function display
Press the [NEXT] button repeatedly until
"S.F.C" appears.
Refer to
8).
3
Enter Sound Field Control mode
Turn the [VOL] knob to select "S.F.C".
Press the [VOL] knob.
• To get the best sound, first set the Cabin Setting
and Speaker Select Front/Rear parameters using the
• When "2ZONE" of
cannot select "S.F.C".
4
Select the Sound Field Control item to
adjust
1 Turn the [VOL] knob to select the item you
want to select. Press the [VOL] knob.
2 Press the Control knob.
3 Push the Control knob towards [FM] or
[AM].
1
2
3
Sound Field control item
"X'Over" "HPF Front" "fc"
"SLP"
Front High Pass Filter Frequency
Front High Pass Filter Slope
"HPF Rear"*¹ "fc"
"SLP"
Rear High Pass Filter Frequency
Rear High Pass Filter Slope
"LPF
SubWoofer"*²
"fc"
"SLP"
"Phase"
Subwoofer Low Pass Filter Frequency
Subwoofer Low Pass Filter Slope
Subwoofer Low Pass Filter Phase
"DTA"
"DTA Front"
DTA Front
"DTA Rear"*¹
DTA Rear
"DTA
SubWoofer"*²
DTA Subwoofer
"POSI"
Position Setting
"Preset"
Preset value storage/recalling
• "Preset": You can store an adjusted sound control
value by selecting "Memory". Refer to
can recall it by selecting "Recall". Refer to
• You can adjust "SubWoofer" when Output> (page 11) is set to "SUBWOOFER ON". • X'Over (Crossover Network Setup) You can manually set a crossover frequency for the • DTA (Digital Time Alignment) Manually set the sound output timing of each • * 1 You can control this item when Speaker Select Rear of • * 2 You can control this item when Speaker Select Subwoofer of 5 Adjust the Sound Field Control item Push the Control knob towards [ 4] or [ ¢]. Each time you push the knob, the setting Sound Field Control Item Range Front High Pass Filter Frequency/ Through/30 — 100/120/150/ Front High Pass Filter Slope/ -12/-18/-24 dB/Oct Subwoofer Low Pass Filter Frequency 30 — 100/120/150/180/220/ Subwoofer Low Pass Filter Phase Normal/ Reverse DTA Front/DTA Rear 0 — 610 (cm) Position Setting Front-Left/ Front-Right/ • When the "2ZONE" of "ON", the following setups are ignored. 6 Exit Sound Field Control mode Turn the [VOL] knob to select "Return".
speakers.
channel.
any item other than "None".
13) is set to any item other than "None".
alternates between the settings shown in the
table below.
Rear High Pass Filter Frequency
180/220/250 (Hz)
Rear High Pass Filter Slope/
Subwoofer Low Pass Filter Slope
250 (Hz)/Through
DTA Subwoofer
Front/ ALL
- "X'Over"
- "DTA"
- "POSI"
- "Preset"
Press the [VOL] knob.