Kenwood XXV-01D - Manual (Page 18)

18 | English
General features
Display Type Selection
Changing the display mode.
1 Show the Multi-function display
Press the [NEXT] button repeatedly until
"Display" appears.
Refer to (page
8).
2 Enter display control mode
Turn the [VOL] knob to select "Display".
Press the [VOL] knob.
3 Select the display mode
Turn the [VOL] knob to select "Mode".
Press the [VOL] knob.
4 Select the display Type
Push the Control knob towards [ 4] or
[ ¢].
Each time you push the knob, the display mode
alternates between the display modes shown in
the table below.
Display Mode Display
"Display Type A" 8
"Display Type B" 8
7
"Display Type C" 1
2
3
4
5
"Display Type D" 1
2
3
4
6
"Display Type E" 9
1 1st text display part
2 2nd text display part
3 3rd text display part
4 4th text display part
5 Indicator display part
6 Icon display part
7 Text display part
8 Graphic display part
9 G-Analyzer display part
5 Exit display control mode
Turn the [VOL] knob to select "Return".
Press the [VOL] knob.
• Change the information by the Display Type. Refer to
the page on the following table for the methods to
alternate by the Display Type.
Display Type A B C D E
1st text 1 — — 21 21 —
2nd text 2 — — 21 21 —
3rd text 3 — — 21 21 —
4th text 4 — — 21 21 —
Icon 6 — — — 24 —
Text 7 — 20 — — —
Graphic 8 18 18 — — —
G-Analyzer 9 — — — — 25
Display Type A/ Display Type B
Graphic part/ Spectrum Analyzer
Display Switching
Changing the graphic Display/ Spectrum analyzer
display.
1 Show the Multi-function display
Press the [NEXT] button repeatedly until
"Display" appears.
Refer to (page
8).
2 Enter display control mode
Turn the [VOL] knob to select "Display".
Press the [VOL] knob.
3 Select the display mode
Turn the [VOL] knob to select "Mode".
Press the [VOL] knob.
4 Select the display Type
Push the Control knob towards [ 4] or
[ ¢].
Select the "Display Type A"/ "Display Type B"
display.
5 Select the graphic/ spectrum analyzer
display
Turn the [VOL] knob to select "SA/GRPH".
Press the [VOL] knob.