Kenwood 50 MHZ ALL MODE TRANSCEIVER TS-590S - Manual (Page 67)

8 EXPANSIVE APPLICATION SOFTWARE
TS-590S CONTENTS 61
If ARUA-10 and ARCP-590 are used in combination, you have only to connect the TS-590S and a
PC with a single USB cable to use the microphone and speaker connected to the PC in place of
those on the transceiver. To use ARCP-590 over a USB cable connection, the virtual COM port
driver needs to be installed.
If you use only ARUA-10 over a USB cable connection, the virtual port driver doesn’t need to be
installed. If you use the built-in USB sound function of the TS-590S only, the function runs on the
Window’s standard driver.
ARUA-10 bridges the TS-590S’s built-in USB sound function (USB audio device) and the sound
device that controls the microphone and speaker on the PC.
A voice signal from the microphone connected to the PC is input into the modulation input of the
TS-590S’s USB audio device. The audio output of the TS-590S’s USB audio device is emitted from
the PC’s speaker.
Figure 8-10 Flow of the Audio Signal
Configure the necessary settings to use ARUA-10.
Right click the “ARUA-10” icon in the Windows task tray and select “Device Setup” in the menu and
the Setup dialog box will appear. In the Device tab, you can set up the device to input/output the
audio signal.
8.5.1 Basic Functions
8.5.2 Operation
8.5.3 Setup